• Substitutes 3 different components (2 ball valves and one filter)
• Reduces leakage risks due to lower sealing points
• Cost saving due to reduced number of components
• Time saving at installation and maintenance
• Built-in vertical filter with cartridge structure in AISI304 (filtration degree: 500 microns / 35 mesh).
• No metal-to-metal moving parts
• Handle clearly shows ball position
• Chrome plated brass ball for longer life
• Handle stop on body to avoid stress at stem
• Water glycol ready

•  Nominal port

• Hot forged sand blasted, external nickel plated brass body and cap sealed with Loctite® or equivalent thread sealant
• Finest brass according to EN 12165 and EN 12164 specifications
• Bottom plug for an easy filter maintenance

• Geomet® carbon steel handle with thick PVC dip coating.
  Handle coating offers both thermal and electrical protection
• Handle removable with valve in service
• WARNING: do not exceed reasonable temperature and/or electrical load

• Blowout-proof unplated brass stem
• Double EPDM O-rings at the stem for maximum safety

• Shell rating: 30 bar (450 PSI) non-shock cold working pressure for sizes 3/4” and 1”, 20 bar (290 PSI) for sizes 1 ¼” to 2”
• -20°C to +160°C (-4°F to +320°F)
• WARNING: freezing of the fluid in the installation may severely damage the valve
• WARNING: with pressure differentials higher than 2 bar, cleaning operation is mandatory (refer to Installation, Maintenance and Operating Instructions provided with the valve)

• Pure PTFE seats

• T-handle

• ISO 228 parallel female by female threads

• According to 2014/68/UE, 1.¼” and superior sizes cannot be used with dangerous fluids

• RoHS Compliant (EU)
• EAC – Declaration of conformity (Russia, Kazakhstan, Belarus)

NOTE: approvals apply to specific configurations/sizes only.