• Substitutes 3 different components (2 ball valves and one filter)
• Reduces leakage risks due to lower sealing points
• Cost saving due to reduced number of components
• Time saving at installation and maintenance
• Built-in vertical filter with cartridge structure in 1.4301 / AISI304 + Nylon (filtration degree: 500 microns / 35 mesh).
• Final test conforming with UNI EN 12266-1 points A3 / A4 (for 1 ½” and 2” sizes: acc. to directive 2014/68/UE)
• No metal-to-metal moving parts
• Handle clearly shows ball position
• Chrome plated brass ball for longer life
• Handle stop on body to avoid stress at stem

• Nominal port

• Hot forged sand blasted, external nickel plated brass body and cap sealed with Loctite® or equivalent thread sealant
• Finest brass according to EN 12165 and EN 12164 specifications
• Bottom plug for an easy filter maintenance

• Zinc plated steel handle with plastic cover
• WARNING: do not exceed reasonable temperature and/or electrical load

• Blowout-proof unplated brass stem
• Two O-rings at the stem (FKM + NBR) for maximum safety

• 30 bar (450 PSI) non-shock cold working pressure for sizes 3/4” to 1”, 20 bar (290 PSI) for sizes 1 ¼” to 2” • -20°C to +100°C (-4°F to +212°F)
• Valve conforming with directive 2014/68/EU
• WARNING: freezing of the fluid in the installation may severely damage the valve

• Pure PTFE seats

• T-handle for ½” to 1” sizes

• ISO 228/1 parallel female by female threads

• According to 2014/68/UE, 1 ¼” and superior sizes cannot be used with dangerous fluids

• Water Regulations Advisory Scheme (United Kingdom)

NOTE: approvals apply to specific configurations/sizes only.